• Ford Galaxy Door Removal
• Honda Door Panel Removal

.Tools required. Sharp knife. Wide flat-blade screwdriver or similar tool. Medium-sized Phillips-head screwdriver (cross-head, No 2 size).

Torx T27 driver, although most people may only have a T25 driver, which will work, but with a loose fit.Method. Remove the circular screw covers on mirror cover (fronts) and door handle recess using a sharp point (knife?). Be very careful not to lose them when they fly out, and take care not to mark the plastic.Ignore the tweeter in this shot, and you may prefer to use two hands if you're not also holding a camera. If you can reach it, the tool needs to be inserted in the top right part of the plastic cover rather than in the position shown in the pic, as this may leave the cover scratched or damaged:. (Fronts only) Remove Phillips screw from mirror cover and remove mirror cover. It is held in with a fairly strong spring clip at the top: just pull firmly and it'll come. Remove Torx screw (T27) from door handle recess.

Once the screw is out, pull off the trim surrounding the door handle. This will be much easier if you 'pull' the door release handle into the open position, as it will give the piece more room to pass the handle. The door pull (the bit you put your fingers in to pull the door shut) is lined with a plastic L-shaped piece (bottom and 'fingers-side') which needs to come out. Using a flat blade screwdriver or similar tool in the gap between the top right hand edge of the the door trim, carefully but firmly push it away from you to unclip it, then lift it out:.

Ford Galaxy Door Removal

Remove Phillips screws from door pull recess: 2 in front doors, 1 in rears. Remove Phillips screws from around the door: 6 on front doors and 4 on rears. Remove the door card by lifting it up and out. You'll need to remove the connector from the window switches - there's a locking tag to manipulate to get them to release.Window switches are clipped in from behind. If you remove them, make sure you get all clips to catch when re-fitting, as it is annoying to have to remove the door panel again when you haven't got one of them in and the switch starts dipping at the unsecured end.

Also, don't forget to reconnect the electrical connector before re-fitting the door card.

Hi Paul,Most Ford doors are a simple enough process. Although not familiar with the Galaxy specifically, you will likely find that the lower portion of the doors grab handle (underneath the window switches) the bottom half can be removed with a trim removal tool, spatula, or protected screwdriver. Behind here is ordinarily two 10mm's bolt or around that size. Remove these. Also, the plastic trim around the door handle can often be removed as well, so that would slide out.

If there are any screws or bolts under there, remove those.To remove the door card, you need to pry the door card away from the door, then firmly pull it away from the door. You will likely need to replace the door fixings (couple of quid off ebay) when you go about reinstalling the door.

I had to do this after removing them from my CMAX.Then you can do whatever work you need to do and reinstall is a reverse.When you say that its loose, what exactly do you mean? It 'wobbles' before it actually starts to really pull the rod top open the door?

Honda Door Panel Removal

If so, you might find that you need to replace the door lock rod.